If the installation of the system must be aware of the details and materials will be used to prolong life.
If hard water or minerals dissolved and suspended solids must be treated before use. Without treatment, temperature, salts are deposited in water, form crusts, which will significantly reduce system performance on the water lines. Therefore taken to protect against corrosion, obstruction of undesirable phenomena pipes, valves to prevent premature wear, increased energy consumption and increased risk of failure. Insulation, installation of underground pipes to a depth below the minimum depth of the frost line. Piping installed above ground must be isolated. The minimum thickness of the insulation of pipes depends on several factors. if the pipes apparently increased 4 mm and 9 mm in unheated rooms in heated rooms where the columns and pipes installed in the channels if they are separated by 4 mm, 13 mm, if it is near the pipe hot water.
One very important thing, plumbing for interior elements of the construction and repair: steel pipe is recommended to use hooks and straps. You can connect the same material as the pipe, particularly for plastic pipes. are large diameter horizontal pipes with the help of media type on the floor. The channels should not bear the weight of steel parts and water meters - is the structure of the building separately.
Plastic pipe and copper should support a shortest distance between two consecutive steel tubes. Cruces components (walls, floors) by the wrists. The tube is in mechanical contact with the sleeve, otherwise the noise and vibration that propagates along the pipeline must be submitted to the building. In addition, the spaces between the pipe and sleeve with an absorbent material (eg rubber), expansion and contraction of the order filled additional noise produced by friction.
Cracks in pipes usually occur because of the land or building or weight due to severe shock. If the pipes are laid in the channels and is limited to direct construction can prevent such an event. Otherwise, can support distances to deformation of the tube and tube fitting close to a heat source or lack of insulation leads to an expansion or contraction.
Protecting your system is well equipped to take into account some things to check regularly. First, keep an installation plan in a safe place. A copy would be better to be safe near the water meter. In the vicinity of the branches is good to have pictures and drawings as a guide. Regularly check the water meter to sudden changes in water.Establish a plumber to check the frequency of operation of all valves, depending on the quality of water and pipe material, operation of all accessories, three times a year. Spin-valves are useful for preventing at least once every three months from the date of the crust to the surface. Check the filter at least twice a year and when water supply is interrupted. After a few when the system is not used, must be thoroughly washed inside with enough water.